Measuring Side Gusset Pouch

Greetings to our page on the explanation for measuring side gusset pouches being produced at Stand Up Pouches. Packaging is a vital aspect of marketing because it acts as a conduit between you and the final user. The packaging can also attract new users towards a product and encourage them to buy the same. The information and design of the packaging whether it is a side gusset bag, flat barrier bag or a stand up pouch, needs to be created by a professional and so we at Stand up Pouches have made a name for ourselves.

Knowing Our Company Better:

We at Stand Up Pouches have been a part of the packaging industry for over three decades. Our establishment was in 1980, following which we have worked endlessly to become pioneers of the market today. Our global outlook towards the market has got us to enjoy far reaching clients who turn to us for their pouch packaging purposes. While our name suggests our specialty in stand up pouches, we have also developed pouch packaging with side gusset and simple packaging pouches for our clients.

We raise the bar high:

We, at Stand Up Pouches, would like to notify existing as well as potential clients about the technique used in measuring side gusset pouches. This technique differs from the one used to measure stand up pouch packaging. However like stand up pouches, the measurements are taken from the outside edge of the bag.

The first step to measuring side gusset pouches is to get the width of the bag. This is best done when you measure from end to end, to see the width. The second step is to measure the height of the pouch packaging which is also taken from end to end by measuring top to bottom. This is done including the seal and hang hole on the bag. Lastly, one must measure the side gusset on the packaging pouches which is done by laying the package flat and sliding the ruler into the side gusset till it reaches the center. This gives you the measure of one side flap of the side gusset, which when multiplied by two, would give the total measure. Since both left and right side gussets are always the same measure, measuring one side is sufficient.

Another thing to consider, while measuring packaging pouches, is the central seal. This flap is usually 10mm but if not considered could disrupt the design that needs to be printed on the pouch package.

Put it in a Packaging Pouch:

Turn to Stand Up Pouches to get high quality packaging pouches, including stand up pouches at cost effective prices and coordinate your efforts with our experts to get best results.

USA
2320 NW 102nd Place
Miami, Florida 33172
Tel: 305-456-7484
Fax: 305-456-5453
Email: info@standuppouches.com
Copyright © 2010 All rights reserved.